6850 Otis selector

greenspun.com : LUSENET : Elevator Problem Discussion : One Thread

Can anyone give me guidance on setting selector limits 1SL, 2SL, 3SL, and 4SL on the 6850 Otis selector? Any help will be appreciated.

-- Robert Barger (sbarger@uark.edu), December 16, 2000


Sure, Tell me the speed of the car and the Selector Ratio. The selector ration can be found on the vernier dial at the botton of the leveling cam shaft.i.e 60:1 120:1 etc.

-- ken Fulkerson (Ken@Elevators4u2.com), March 06, 2001.

6850 selectors

settings are determined by ratio of selector [ shown on dial/disk up to 138:1]spd of car , type of load weighing bld,int,fld {shunt]versus 4 through 9 load step switches "These are set to bal load". Mg sets are diffrent comp fields versus load assist. A basic spd setting is close But a chart recorder is extremely helpful.

-- john (kanthackj@aol.com), October 11, 2004.

Moderation questions? read the FAQ