Otis 211 DZ fault, magnet problemgreenspun.com : LUSENET : Elevator Problem Discussion : One Thread
i had an otis 211 that would get a dz fault at the top floor (2 stop) i replaced the magnets at the second floor 3 times before i found a set that worked. all the magnets i used were new, and i'm sure they were aligned properly. i tried the selector card in another car and it worked fine. anyone ever see this? possible weak magnets AND weak field effects????? thanks rob local #140
-- rob wood (email@example.com), May 21, 2002
yes i have does your car move in the rails these magnets need close tolerence to work if your car moves they may miss the magnet
-- jag (firstname.lastname@example.org), May 22, 2002.
211 MAGNETS HAVE HOLES ..NEED A COMPASS TO CHECK IF MAGS ARE GOOD OTHERWISE A NEW READER CHECK PLUG INSIDE OF COP IHAVE 50...211 UNITS
-- FONZIE (DARKAA@AOL.COM), March 04, 2003.
Sometimes you need to turn the magnet over.
-- Thomas Sleys (email@example.com), August 26, 2003.
I think your sensor is to much sensibile. I have this problem becouse the sensor reeds the magnetic field at 35 cm !!!! You don't belive becouse is unbelivebal, but is the truth. Try to change the sensor. Best regards, Ottavio
-- oktav (firstname.lastname@example.org), August 30, 2003.